I wanted to use some vinyl so i could recreate my logo physically and put it on objects i might not of been able to put on. So the document i set up is below, i separated out the logo incase the vinyl cutter couldn't handle how close the others were, but not only this but also because it cant print colours so having the separated colours would be easier to transfer on to my objects. So i brought a pump a puncture repair kit and a tool kit that would be handed out to people at then event so if they are in trouble and for some reason they cant contact anyone they can use these.
The small circles are for the puncture repair kit and pump and the larger ones are for the tool kit bag.
I firstly removed all the excess vinyl i didn't need and then removed the circles that were on the inside of it.
I then started to apply this to the object i had, it was hard to line everything up with eye because they were so small and because i had to put the circle exactly in the centre.
I feel like i did a good job though and they came out really well
I then did the same process for the tool kit and the pump.
With the pump i split the logo and had 2 circles on one side and anther 2 on the other
I really liked how the logo turned out on the pump because as it was lifted the logo was revealed.
I then added one of the circles to the t shirt, these would then have a different circle on each t shirt and a different colour, the people who are stood around the track would wear these so the people taking part would know they were heading in the correct direction, but also they would be able to ask the relevant marshall for information to the track they were racing on.
No comments:
Post a Comment